Dollar Bill-Ring

Fold the bill in 1/2

1. Lets Make A Dollar Ring:)

Get a dollar bill & lay it Flat

Repeat last step-(fold in 1/2 again)
(NOTE: you may also fold it again to make it skinnier)

Fold in your corner 'bout 1 inch-(on right hand corner)

fold left hand side in 'bout 1/4 of an inch
(or less depending on size of finger).

7. take the folded 1/2 inch side (on the right)
& roll it over your finger to kinda measure you'r finger size.
then bring the 1/4 folded end down.

8. then fold over the 1/2 inch side so its facing towards left hand side.

9. then bring up the bottom tail part (that has the 1/4 folded
end on it, & tuck it in.

Finishing Touches

Then for the final finish, fold the last pc. in underneath where
your finger goes, & Put it on.
Good Luck & I hope It Works Out For You!